The same directions as week five. This is just my blue version. I did use All Is Calm DSP for the snow and the Santa and sleigh is stamped in Lost Lagoon. The light pole is in basic black. I love this stamp set!! Base card is soft sky.
CutColorPaste is a place to get ideas and to share thoughts. I love to share my love for papercrafting. You are welcome to duplicate any project you see.Please if you are a demonstrator and purchase a tutorial for a class please purchase one for each guest. I have put alot of time into creating these classes for you. I love to share everything but please give me the acknowledgement for my work, thanks Have fun and create, create, create. Your comments are always welcome.
Nov 8, 2014
Nov 6, 2014
Week#5 Christmas houses
Base card is 8.50 x 5.50 I scored it on the 8.50 side at 4.25. Now when reading my instructions I will tell you I use my stampinup paper trimmer upside down. The logo is upside down and thr trimming bar is on the left side of my cutting platform. Now that is out of the way. Here are the instructions.
Line up the cardstock on the 5.50 side and bring the right side down to the 3 inch mark. So when you cut in it will be 2.50 inches wide. I use a piece of a post it note to mark my cutting mark which will be at the 1 inch mark and stopping at the 6.50 mark. Then you will turn your card stock to the 8.50 side and your fresh cut 2.50 will be at the top. Line up the right edge at the 7.5 and score up to the 3 inch mark again use a post it note to mark your stopping point so your score marks should be as you go 7.50-6.50-5.25-4-2. Reminder you are working from the right sliding your cardstock to the left.
Fold your score mark on the 2.5 width side in mountain fold see picture below.
Now to fold your mountains and valleys on the 3 inch side start at the front of the card with the first 1 inch mountain, and keep folding mountain-valley-mountain-valley-large mountain. Refer to photo.
I added a 1x5.50 strip of whisper white on the front of the card add your trees and your red house. Add an additional strip of whisper white 1x5.50 strip cut the top into hills before you tape down. Also cut your white glitter paper into a slight slope. If you like your card with out the glitter paper save it for something else. Add your houses in each valley according to the photo and glue in place.
These pieces are embossed in white embossing powder.
Line up the cardstock on the 5.50 side and bring the right side down to the 3 inch mark. So when you cut in it will be 2.50 inches wide. I use a piece of a post it note to mark my cutting mark which will be at the 1 inch mark and stopping at the 6.50 mark. Then you will turn your card stock to the 8.50 side and your fresh cut 2.50 will be at the top. Line up the right edge at the 7.5 and score up to the 3 inch mark again use a post it note to mark your stopping point so your score marks should be as you go 7.50-6.50-5.25-4-2. Reminder you are working from the right sliding your cardstock to the left.
Fold your score mark on the 2.5 width side in mountain fold see picture below.
Now to fold your mountains and valleys on the 3 inch side start at the front of the card with the first 1 inch mountain, and keep folding mountain-valley-mountain-valley-large mountain. Refer to photo.
I added a 1x5.50 strip of whisper white on the front of the card add your trees and your red house. Add an additional strip of whisper white 1x5.50 strip cut the top into hills before you tape down. Also cut your white glitter paper into a slight slope. If you like your card with out the glitter paper save it for something else. Add your houses in each valley according to the photo and glue in place.
These pieces are embossed in white embossing powder.
Nov 1, 2014
BEST COSTUME EVER!!!
I have been very blessed in my life with wonderful women that fill my life with complete joy. I am thankful everyday for these blessings as my friends have carried me through some very difficult times in my life. With that being said may I introduce you to a very special gal pal I run with. Her name is Mary and I have a very special place in my heart for her. My favorite gals have been going on a crafting retreat for the last few years and it is my most favorite time of year. I absolutely love Halloween. This girl dressed up as my BLOG and it was so touching I laughed until I cried. It was so amazing that she took the time and effort into making my day, but then I expect nothing less from her. Thank You Mary for making me smile!
Oct 26, 2014
Snowman Tealights WEEK #4
I just fell in love with this project. I think I first saw these done by Becky Roberts but I loved the way mine turned out! These can be made into pins or ornaments. Even a magnet!
Snowman tea light box
5.50x6.50
Score at 1.75 in all 4 sides
Lid
4.1/8 x 3 1/8 score .50 on all 4 sides
Punch label punch in the middle of the lid add window sheet.
Window sheet is
1.75x2.75
DSP All is calm cut 2.50 x 1.50 and 1.75x 1.50 for the sides of the box
Card stock colors pear pizazz, pool party, white, lost lagoon
Tie with white ribbon 12 inches long. Stamp tag in lost lagoon and add a snowflake in pool party. Tie on with bakers twine.
To make the snowman you will need a battery operated tea light
To make the snowman using white card stock
Punch in the center of white paper using the circle punch from trio.mini punch pack. Then center the punched circle in the 1 3/8 Circle punch.
Large pearls colored with a black sharpie for eyes.
Small pearls also colored In black for mouth
Using the Blossom builder punch; punch designer paper with the petal side. Then using the large scallop punch for the brim, punch the arch in the brim using the retired small oval punch. The tassel is punched using the mini scallop circle also from the Mini Trio. I used the sweater trim from last year to tie around the Tea light like a scarf. I used very little paper shreds inside the box and tied it off with white satin ribbon. Enjoy!
Oct 19, 2014
Shaker Card Christmas Week #3
For this beautiful card I used the following items;
Cardstock: Old Olive, Very Vanilla, Brushed Gold, Gold Glitter Paper, Vellum, Window Sheet
Inks:Old Olive, Soft Sky, Encore Gold
Stamp Set:Festival Of Trees
Punches: Tree, Confetti Stars, 1 3/4 circle, 1 1/4 scallop circle, Modern Label
Embossing Folder: On Point
Embellishments: Gold Bakers Twine, Shaker Frames, dimensionals
Framelits: Circles
Base Card is cut 4.25x11 Layer One: very Vanilla 4 x 5.25 (emboss with the on point folder and from the center top as far as your 1 3/4 punch can go; punch a circle. Using a 3x3 sheet of very vanilla and a scrap piece of cardstock to punch a scallop circle from; take your soft sky ink and create clouds with a sponge. Set aside. stamp 2 trees on your vellum and punch out. Use a strip of brushed gold 1.25 x 4.25 and punch your stars. Now tape your trees onto the 3x3 piece of cloudy very vanilla. Keep in mind the whole tree wont show just the tops. Pile the confetti stars in the middle.
Going back to the 4x5.25 embossed very vanilla on the back side tape down a 3x3 window sheet, then place the largest shaker frame around the punched circle. Peel off the sticky sheet and turn over center this piece over your Old olive Cardstock and it should perfectly circle your trees and stars.
Tie your bakers twine around the lower half. Then add a dimensional to each corner. Stamp an accent tree on Very Vanilla in Gold dry with a heat gun and punch. Using dimensionals pop it up on the front. Using your circle framelits and a 3x3 sheet of gold glitter paper and your Bigshot cut out a circle using the 2 inch circle and the next size up. I glued this in place with Tombo quick dry glue. On a scrap piece of very vanilla stamp your greeting and punch out using the modern label punch and pop up with dimensionals. Cut another 4x5.25 for the inside greeting, you can decorate the inside with the gold strip you punched the stars out of if you desire.

Before the front is in place
Cardstock: Old Olive, Very Vanilla, Brushed Gold, Gold Glitter Paper, Vellum, Window Sheet
Inks:Old Olive, Soft Sky, Encore Gold
Stamp Set:Festival Of Trees
Punches: Tree, Confetti Stars, 1 3/4 circle, 1 1/4 scallop circle, Modern Label
Embossing Folder: On Point
Embellishments: Gold Bakers Twine, Shaker Frames, dimensionals
Framelits: Circles
Base Card is cut 4.25x11 Layer One: very Vanilla 4 x 5.25 (emboss with the on point folder and from the center top as far as your 1 3/4 punch can go; punch a circle. Using a 3x3 sheet of very vanilla and a scrap piece of cardstock to punch a scallop circle from; take your soft sky ink and create clouds with a sponge. Set aside. stamp 2 trees on your vellum and punch out. Use a strip of brushed gold 1.25 x 4.25 and punch your stars. Now tape your trees onto the 3x3 piece of cloudy very vanilla. Keep in mind the whole tree wont show just the tops. Pile the confetti stars in the middle.
Going back to the 4x5.25 embossed very vanilla on the back side tape down a 3x3 window sheet, then place the largest shaker frame around the punched circle. Peel off the sticky sheet and turn over center this piece over your Old olive Cardstock and it should perfectly circle your trees and stars.
Tie your bakers twine around the lower half. Then add a dimensional to each corner. Stamp an accent tree on Very Vanilla in Gold dry with a heat gun and punch. Using dimensionals pop it up on the front. Using your circle framelits and a 3x3 sheet of gold glitter paper and your Bigshot cut out a circle using the 2 inch circle and the next size up. I glued this in place with Tombo quick dry glue. On a scrap piece of very vanilla stamp your greeting and punch out using the modern label punch and pop up with dimensionals. Cut another 4x5.25 for the inside greeting, you can decorate the inside with the gold strip you punched the stars out of if you desire.
| The front before placed over the trees. |
Before the front is in place
Oct 12, 2014
Week 2 in 12 weeks of Christmas Contemporary Celebration
Oct 5, 2014
Hershey Bar Holders Week One in 12 weeks of Christmas
1. Cut your base cardstock 3x11
2. score each end at 3.50
3. Cut your DSP 2.75x3.25 ( I used Nordic Noel)
4. Cut your bellyband 1x11 your will trim it into a banner
5. use one glitter brad or candy dot brads in brights
6. Ink is Real Red or Garden Green
7. Stamp Set is Tags 4 you and the bracket punch
8. You will need a Window word punch for the candy slot. I closed the sides
with red line tape.
![]() |
| score each end at 3.50 |
![]() |
| fold and add dsp to the front panels |
![]() |
| Punch your candy slot |
![]() |
| add your redline tape peel and just before closing add hershey snack size bar |
Sep 28, 2014
Tasty Treat Holder
Base cardstock is 3 x11. Score each end at 3.50
DSP (designer series paper) 2 pieces 3.25x 2.75
Belly band 1x12 inches
1 brad
Window word punch for the candy slot.
Red line to assemble
Tag note punch bundle
Add the DSP to the front and the inside fold. using the window word punch; punch a slot large enough to fit a snack size Hershey bar. Add your bar and the red line on each side. peel tape and fold down. Close and add your belly band. Cut tails and add brad. Stamp and punch tag using Dimensionals pop it up on the belly band so it can easily be removed.
DSP (designer series paper) 2 pieces 3.25x 2.75
Belly band 1x12 inches
1 brad
Window word punch for the candy slot.
Red line to assemble
Tag note punch bundle
Add the DSP to the front and the inside fold. using the window word punch; punch a slot large enough to fit a snack size Hershey bar. Add your bar and the red line on each side. peel tape and fold down. Close and add your belly band. Cut tails and add brad. Stamp and punch tag using Dimensionals pop it up on the belly band so it can easily be removed.
Sweet Treat
I made this cutie using candy, raffia, and a low temp glue gun. The Pumpkin head candies are bought from the local dollar store. The smarties and tootsie rolls were a steal at Menards. Milk duds or Dots boxes both work. Enjoy!
Subscribe to:
Posts (Atom)






